CNC Machine

Circuit-Zone.com - Electronic Projects

Posted on Wednesday, February 9, 2011 • Category: CNC Milling Devices

The electronics of a CNC machine is a simple but often confusing matter. In the picture (down) is shown the schema of a full system of four axes. Sometimes the breakout board is not present and the parallel port connected directly to the controllers. The main advantage of using single stepper controllers enable the user to connect different motors even in a mixed configuration (unipolar or bipolar steppers) tuning the CNC machine performances to the job to be done. A common and simple solution is the use of a board where the optoisolator (if any) and the controller/drivers are present in the same board, all-in-one. This solution allow a general quicker connection and a simple wiring but force the use of three or four identical (or similar) stepper motors.

3-Axis CNC Milling Device

CNC Machine

Build Accurate LC Meter and start making your own coils and inductors. This LC Meter allows to measure incredibly small inductances making it perfect tool for making all types of RF coils. LC Meter can measure inductances starting from 10nH - 1000nH, 1uH - 1000uH, 1mH - 100mH and capacitances from 0.1pF up to 900nF. The circuit includes an auto ranging and reset function to make sure the readings are as accurate as possible ... [more]